L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures page 22

K1 K1 K1 K1
reference wst reference wst reference wst reference wst
RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES
VERSION 2.0
5. Select the 0° angle for both angle arms on top of TOWER#1: remove the R-BLP from the shipping location, hold
it facing to the 0° angle hole, and slide out the angle arm until the R-BLP enters and locks.
Figure 15: 0° angle setting
6. Attach the K1-BUMP to the TOWER#1 as described below (see also Figure 16):
a. Remove the four R-BLP from the K1-BUMP main frame and let them hang.
b. Lower the K1-BUMP so as to align the front rigging points with both angle arm oblong holes on the
TOWER#1 and attach them (use two R-BLP).
c. Lift both rear arms out of TOWER#1 and attach them to the K1-BUMP (use two R-BLP).
The K1-BUMP must be installed with laser slits oriented towards the front of the array (or REAR
identification plate towards the rear, as it is shown in Figure 16).
WARNING
K1_RM_EN_2-0
® ® ® ®
system system system system
Shipping location
w w w . l - a c o u s t i c s . c o m
Angles
set at 0°
20 20 20 20