L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures page 40

K1 K1 K1 K1
reference wst reference wst reference wst reference wst
RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES
VERSION 2.0
9. Remove both S-BLP (straight ball-locking pin) from each K1-PLA by pulling on the lanyards.
10. Raise the array until the enclosure#1 is flown, K1-BUMP in the horizontal position (the K1-PLA should separate
from enclosure#1).
11. With 2 people (one on each side) lift the front of enclosure#1 and attach both angle arm oblong holes to the K1-
BUMP front rigging points (use two R-BLP).
.
b
L
.
a
L
Figure 36: Attaching front rigging points between enclosure#1 and K1-BUMP
K1_RM_EN_2-0
® ® ® ®
system system system system
Figure 35: Removing S-BLP from K1-PLA
w w w . l - a c o u s t i c s . c o m
38 38 38 38