Array Removal - L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures

K1 K1 K1 K1
reference wst reference wst reference wst reference wst
RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES
VERSION 2.0
18. Raise the array until the K1-CHARIOT wheels reach 0.3 m/1 ft eight.
19. Remove the K1-CHARIOT from TOWER#2 by repeating step 10.
20. For arrays of more than 8 enclosures repeat steps 11 to 19 until all TOWERS composing the array are flown.
21. If a KARA downfill array is intended to be rigged, attach it under the bottom K1 [6.4.2].
22. Fly the array at desired trim height and adjust the site and azimuth angles [9.4-9.5].
23. Secure the K1-BUMP to the main rigging structure using two safety slings (not provided) [9.2].
6.2.3

Array removal

All along the disassembling procedure:
•
Strictly follow the sequence of the successive steps.
•
Ensure that each BLP is fully inserted by pulling on it.
WARNING
For clarity purposes the loudspeaker cable removing procedure will not be described.
The loudspeaker cables will not be represented on the figures.
IMPORTANT
1. Detach both safety slings from the K1-BUMP [9.2].
2. If a KARA downfill array has been rigged, remove it from the bottom K1 [6.4.3].
3. Lower the array at 0.3 m/1 ft height.
4. Attach a K1-CHARIOT to the bottom enclosure as described below:
a. Align both rear rigging points between the K1-CHARIOT and the bottom enclosure.
b. Attach both rear rigging points (use two R-BLP).
c. Hold the K1-CHARIOT and attach both front rigging points (use two R-BLP).
c.
L
K1_RM_EN_2-0
® ® ® ®
system system system system
b.
L
a.
L
Figure 23: Attaching K1-CHARIOT
w w w . l - a c o u s t i c s . c o m
b.
L
28 28 28 28