L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures page 4

Hide thumbs Also See for K1 REFERENCE WST SYSTEM:
Table of Contents

Advertisement

K1
K1
K1
K1
reference wst
reference wst
reference wst
reference wst
RIGGING PROCEDURES
RIGGING PROCEDURES
RIGGING PROCEDURES
RIGGING PROCEDURES
VERSION 2.0
9.
Suspension points
It is the user's responsibility to ensure that the Working Load Limit (WLL) of the suspension points and/or
chain hoists is greater than the total weight of the loudspeaker assembly in use.
WARNING
10. System load capacity and setup safety limits
Load capacity and setup safety limits when flying or stacking a loudspeaker assembly should be strictly
followed according to the instructions outlined in this manual.
ALWAYS refer to the mechanical data and warning indications provided in SOUNDVISION software
WARNING
(Mechanical Data section) to verify the mechanical conformity of the system before installation.
11. Local regulations
Some countries require higher Ultimate Strength Safety Factors and specific rigging approvals. It is the user's
responsibility to ensure that any overhead suspension of L-ACOUSTICS
accordance with all applicable local regulations.
WARNING
12. Flying a loudspeaker assembly
Always ensure that nobody is standing underneath the loudspeaker assembly when it is being raised. As the
system is being raised check each individual component to make sure that it is securely fastened to the
component above. Never leave the system unattended during the installation process.
WARNING
As a general rule, L-ACOUSTICS
13. Dynamic load
When a loudspeaker assembly is deployed in an open air environment, wind effect should be taken into
account. Wind can produce dynamic stress to the rigging components and suspension points. If the wind
force exceeds 6 bft (Beaufort scale) it is highly recommended to lower down and/or secure the loudspeaker
WARNING
assembly.
14. Manual
Keep this manual in a safe place during the product lifetime. This manual forms an integral part of the
product. Reselling of the product is only possible if the user manual is available. Any changes made to the
IMPORTANT
product have to be documented in writing and passed on to the buyer in the event of resale.
K1_RM_EN_2-0
® ® ® ®
system
system
system
system
®
recommends the use of safety slings at all times.
w w w . l - a c o u s t i c s . c o m
®
systems has been made in
2 2 2 2

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Reference wst system k1K1-bumpK1-deltaKara-downk1K1-chariotK1bump-flight

Table of Contents