L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures page 38

K1 K1 K1 K1
reference wst reference wst reference wst reference wst
RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES
VERSION 2.0
2. On both sides of each enclosure ensure that the ''variable'' setting is selected by pulling on the angle unlocking
latch.
In the "variable" setting a yellow sticker must be visible on the angle unlocking latch.
IMPORTANT
3. On both sides of each enclosure (except for enclosure#1), lift out the rear arm and attach it to the adjacent
enclosure (use two R-BLP).
K1_RM_EN_2-0
® ® ® ®
system system system system
Figure 31: Setting the ''variable'' position
a.
L
Figure 32: Attaching the rear rigging points
w w w . l - a c o u s t i c s . c o m
Yellow
sticker
.
b
L
36 36 36 36