L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures page 57

12. With 2 people working simultaneously on each side of ARRAY#1, disconnect the rear rigging points between
KARA#1 and KARA#2 & 3 as follows:
a. Grab the back handle of KARA#2 and remove the rear bottom link R-BLP from KARA#1.
b. Rotate KARA#2 & 3 downwards and place the rear corners into the flight-case tray.
Figure 58: Rear rigging point disconnection between KARA#2 and KARA#1
13. With 2 people working simultaneously on each side of the array, disconnect the front rigging points between the
KARA-DOWNK1 and the K1 as follows:
a. Grab the front of the KARA-DOWNK1 and remove the front bottom R-BLP from the bottom K1.
b. Rotate the KARA-DOWNK1 downwards until the KARA#3 front corners are installed into the flight-case tray.
c. Re-insert the front bottom R-BLP on the K1.
Figure 59: Front rigging point disconnection between KARA-DOWNK1 and K1
K1_RM_EN_2-0
b.
a.
c.
b.
w w w . l - a c o u s t i c s . c o m
a.
55 55 55 55