L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures page 53

15. Connect both front rigging points between ARRAY#1 and ARRAY#2 as follows:
a. Slide both KARA#4 front arms up and align them with the KARA#3 bottom front rigging points.
b. On KARA#3, remove both front bottom R-BLP from the storage holes and secure by re-inserting them into
the bottom yellow link holes.
c. Take the array down until KARA#3 and KARA#4 front corners are in contact (the front arms must remain
vertical).
d. Secure the front arms on KARA#4 by inserting both top R-BLP into the top yellow link holes.
b.
a.
Figure 52: Front rigging point connection between ARRAY#2 and ARRAY#1
16. Raise the array to a height for which the angle arms of ARRAY#2 are comfortably reachable.
17. With 2 people working simultaneously on each side of the array, connect both rear rigging points between
ARRAY#1 and ARRAY#2 as follows:
a. Remove the KARA#4 rear top R-BLP from storage position, slide the angle arm so as to align the cursor with
the desired angle value, and secure by re-inserting the R-BLP into the corresponding angle hole (0°/2°/4° or
1°/3°/5°/7.5°/10°).
b. While grabbing the back handle of KARA#6, rotate ARRAY#2 so as to align the KARA#3 and KARA#4 rear
rigging points.
c. Remove the rear bottom R-BLP from KARA#3 and secure by re-inserting it into the yellow link hole.
a.
L
Figure 53: Rear rigging point connection between ARRAY#2 and ARRAY#1
18. Set the inter-enclosure angles in ARRAY#2 by applying step 10.
K1_RM_EN_2-0
c.
KARA#3
KARA#4
KARA#3
KARA#4
b.
L
w w w . l - a c o u s t i c s . c o m
d.
c.
51 51 51 51