L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures page 55

3. Place an empty KARA flight-case at the rigging location, remove the lid, and place the tray beneath ARRAY#2.
Pay attention to the tray position: both inner slopes must be inclined upwards from front to rear
(see Figure 55).
WARNING
4. Lower the array slightly higher than the tray.
5. With 2 people working simultaneously on each side of the array, disconnect both rear rigging points between
ARRAY#1 and ARRAY#2 as follows:
a. While grabbing the back handle of KARA#5, remove the rear bottom link R-BLP from KARA#3 and re-insert
it into the bottom storage hole.
b. Rotate ARRAY#2 downwards and place the rear corners into the tray while still suspended from the front
connecting points.
c. Remove the rear top angle R-BLP from KARA#4, slide the angle arm so as to align the cursor with the
storage position, and re-insert the R-BLP into the top storage hole.
a.
Figure 56: Rear rigging point disconnection between ARRAY#2 and ARRAY#1
K1_RM_EN_2-0
Inner slopes
Empty tray
Figure 55: Recommended flight-case for KARA
KARA#3
KARA#4
w w w . l - a c o u s t i c s . c o m
Tray supporting a 3-KARA array
c.
b.
L
L
53 53 53 53