L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures page 47

8. Repeat steps 4 to 7 until all enclosures composing the array are on the ground.
9. Remove all rear R-BLP between K1-BUMP and all enclosures (and put them in their shipping locations) and pull
back the rear arms (they should lock back into the enclosures and a yellow sticker should be visible on each one).
Figure 43: Detaching rear rigging points between all enclosures (including K1-BUMP)
10. Lower the K1-BUMP until it is laid on the ground.
11. If necessary, remove the LA-RAK touring racks from the K1-BUMP by following procedure [6.1.2] in the
reversed sequence.
12. Remove the motor hooks from the K1-BUMP.
13. Set the K1-BUMP in shipping configuration by following procedure [6.1.1] in the reversed sequence.
K1_RM_EN_2-0
w w w . l - a c o u s t i c s . c o m
45 45 45 45