L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures page 39

4. On both sides of each enclosure, pre-select the
angle: hold a R-BLP facing to the desired angle
hole, slide out the angle arm until the R-BLP
enters and locks (see Figure 33).
Note: Select the 0° angle for the enclosure#1
(to align with the K1-BUMP site angle).
5. Prepare the K1-BUMP [6.1.1] and attach the
motor hooks [9.2].
6. If necessary, install LA-RAK touring racks on the
K1-BUMP [6.1.2].
7. Raise the K1-BUMP in the horizontal orientation
to more than 0.7 m/2.3 ft height.
8. On the enclosure#1, lift out both rear arms and attach them to the K1-BUMP rear rigging points (use two R-
BLP).
The K1-BUMP must be installed with laser slits oriented towards the front of the array (or REAR
identification plate towards the rear, as it is shown in Figure 34).
WARNING
.
b
L
Figure 34: Attaching enclosure#1 to K1-BUMP rear rigging points
K1_RM_EN_2-0
Figure 33: Pre-selecting the angles (5° example)
.
a
L
w w w . l - a c o u s t i c s . c o m
REAR identification plate
37 37 37 37