Array Removal - L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures

6.3.3

Array removal

All along the disassembling procedure:
•
Strictly follow the sequence of the successive steps.
•
Ensure that each BLP is fully inserted by pulling on it.
•
Have 3 people working (one operating the hoist controller and one on each side of the
WARNING
array) while raising or lowering the array so as to prevent it from swinging.
For clarity purposes the loudspeaker cable removing procedure will not be described.
The loudspeaker cables will not be represented on the figures.
IMPORTANT
1. Detach both safety slings from the K1-BUMP [9.2].
2. If a KARA downfill array has been rigged, remove it from the bottom K1 [6.4.3].
3. Take down the array until the bottom enclosure is reaching 0.3 m/1 ft height.
4.
Attach a K1-PLA to the first four bottom enclosures (insert both S-BLP on each K1-PLA).
Figure 39: Attaching K1-PLA on the four bottom enclosures
K1_RM_EN_2-0
w w w . l - a c o u s t i c s . c o m
41 41 41 41