L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures page 29

17. Attach the rear rigging points between TOWER#1 and
TOWER#2 as follows:
a. Arrange the K1-CHARIOT front wheels towards interior as it
is shown in Figure 22.
This operation will avoid instability when the
wheels are in contact with the ground.
WARNING
b. With 3 people (one manipulating the hoist controller and two
on both sides of the array grabbing the bottom handles of
TOWER#2), pull towards the back while lowering the array
until both K1-CHARIOT front wheels touch the ground.
c. Continue lowering the array until the TOWER#2 and
TOWER#1 rear corners are in contact.
Stop lowering the array at the exact moment
when both TOWER rear corners are in contact
so as to avoid putting too much stress on the
CAUTION
K1-CHARIOT wheels.
d. Lift both rear arms out of TOWER#2 and attach them to the
TOWER#1 (use two R-BLP).
K1_RM_EN_2-0
w w w . l - a c o u s t i c s . c o m
Figure 22: Attaching TOWER#2 to
TOWER#1 rear rigging points
27 27 27 27