L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures page 45

6. Land the first four bottom enclosures as described
below:
a. With 2 people (one on each side) lift the front of
the bottom enclosure.
b. Pull both front bottom R-BLP of the enclosure
(or bumper) above and put them back in their
storage locations.
c. Lift the front part of the bottom enclosure until it
has reached a stable hanging position.
The rear rigging points must remain
attached to prevent the bottom
enclosure from falling.
WARNING
d. Have two people pulling back the bottom
enclosure while lowering the array until the four
K1-PLA wheels are laid on the ground.
Have one person pulling back the
bottom enclosure at all time while
the array is been lowered.
WARNING
e.
Repeat steps a. to d. three times again.
Have one person pulling back the
first landed enclosure at all time while
the array is been lowered.
WARNING
b.
Figure 41: Detaching the front rigging points
K1_RM_EN_2-0
w w w . l - a c o u s t i c s . c o m
c. d.
43 43 43 43