L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures page 51

7. With 2 people working simultaneously on each side of the array,
connect the front rigging points between KARA-DOWNK1 and K1
as follows:
a. Remove the front bottom R-BLP from the bottom K1.
b. Rotate the KARA-DOWNK1 upwards so as to align the front
rigging point with the K1.
c. Connect the front rigging point by re-inserting the front bottom
R-BLP on the K1.
Figure 48: Front rigging point connection between KARA-
8. With 2 people working simultaneously on each side of ARRAY#1, connect the rear rigging points between
KARA#1 and KARA#2 & 3 as follows:
a. Grab the back handle of KARA#2 and rotate KARA#2 & 3 upwards so as to align the rear rigging point
between KARA#2 and KARA#1.
b. Attach the rear bottom link R-BLP on KARA#1.
c. Raise the array and remove the flight-case tray from the rigging location.
Figure 49: Rear rigging point connection between KARA#2 and KARA#1
K1_RM_EN_2-0
DOWNK1 and K1
a.
c.
w w w . l - a c o u s t i c s . c o m
a.
c.
b.
b.
49 49 49 49