Appendix; Inclinometer Sensor Mounting - L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures

9 9 9 9 A A A A PPENDIX PPENDIX PPENDIX PPENDIX
9.1

Inclinometer sensor mounting

A support plate has been integrated inside the K1-BUMP main frame for remote inclinometer sensor mounting (see
Figure 63). Two sensor models are supported: TEQSAS
refer to the TECH TOOLCASE Product spec sheet [3.4]) and SSE
Note: It is also possible to mount the LAP-TEQ and ProSight sensors to the side face of a K1/K1-SB enclosure using
the K1-LASERMOUNT plate (refer to the K1-LASERMOUNT Technical bulletin [3.4]). The K1-LASERMOUNT
also supports the ALIGNARRAY
LAP-TEQ mounting procedure
Not included material: XLR 3 cable, T20 Torx
medium-strength thread-locker (KR LOCKBLUE).
1. Remove the four M4 Torx
LAP-TEQ template (Figure 63).
2. Put a drop of thread-locker in the 4 threaded
inserts.
3. Install the LAP-TEQ sensor horizontally with laser
lens oriented forwards.
4. Screw in the four M4 Torx
5. Connect the XLR 3 cable to the sensor.
6. Calibrate the inclinometer and laser by following the
manufacturer recommendations.
Figure 64: LAP-TEQ mounted to K1-BUMP
Figure 65: ProSight mounted to K1-BUMP
K1_RM_EN_2-0
®
UVM sensor model.
indentation
Figure 63: Inclinometer mounting plate inside K1-BUMP
®
key,
®
screws (T20) from the
®
screws (T20).
w w w . l - a c o u s t i c s . c o m
®
LAP-TEQ (part of the L-ACOUSTICS
®
ProSight.
ProSight template for
four M6 flat–head screws
Front
LAP-TEQ template with
K1-LASERMOUNT template with four M6 hex screws
ProSight mounting procedure
Not included material: XLR 6 cable, 5 mm hex key, four
M6 flat-head bolts and adapted keys, medium-strength
thread-locker (KR LOCKBLUE).
1. Remove the support plate from the K1-BUMP by
removing the four M6 hex screws (hex 5 mm).
2. Put a drop of thread-locker in the 4 nuts (unless using
self-locking nuts).
3. Install the ProSight sensor horizontally with laser lens
oriented forwards.
4. Screw in the 4 M6 flat-head screw/nut assemblies.
5. Put a drop of thread-locker in the 4 threaded inserts
of the M6 hex screws.
6. Put the support plate back in place on the K1-BUMP
and screw in the four M6 hex screws (hex 5 mm).
7. Connect the XLR 6 cable to the sensor.
8. Calibrate the inclinometer and laser by following the
manufacturer recommendations.
®
TECH TOOLCASE,
(not included)
®
four M4 Torx screws
61 61 61 61