L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures page 52

K1 K1 K1 K1
reference wst reference wst reference wst reference wst
RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES
VERSION 2.0
9. Raise the array to a height for which the angle arms of ARRAY#1 are comfortably reachable.
10. With 2 people working simultaneously on each side of ARRAY#1, set the inter-enclosure angles as follows:
a. While grabbing the back handle of KARA#3, remove the rear top R-BLP from KARA#2.
b. Rotate KARA#2 so as to align the cursor of the angle arm with the desired angle value.
c. Secure by re-inserting the R-BLP into the corresponding angle hole (0°/2°/4° or 1°/3°/5°/7.5°/10°).
d. Repeat for KARA#3.
11. Place another full KARA flight-case at the rigging
location and remove the lid. Direct the front face of
the 3-KARA array towards the audience. In the
following, the array will be designated as ARRAY#2
and the enclosures as KARA#4 to KARA#6 from
top to bottom.
12. Check the inter-enclosure connections in ARRAY#2
by applying step 2.
Figure 51: Inter-enclosure connection check for
13. On KARA#4, take both front arms out as follows (repeat for each one): remove the front top R-BLP, rotate the
front arm up, and slide it down. Do not re-insert the R-BLP.
14. Raise ARRAY#1 slightly higher than the front arms of ARRAY#2 and place ARRAY#2 beneath ARRAY#1.
K1_RM_EN_2-0
® ® ® ®
system system system system
d.
L
Figure 50: ARRAY#1 inter-enclosure angle setting
ARRAY#2
w w w . l - a c o u s t i c s . c o m
c.
a.
L
L
KARA#4
KARA#5
KARA#6
ARRAY#2
b.
L
Cursor
50 50 50 50