L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures page 34

K1 K1 K1 K1
reference wst reference wst reference wst reference wst
RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES
VERSION 2.0
14. Lower TOWER#1 until the K1-CHARIOT four wheels are laid on the ground.
Stop lowering the array at the exact moment when all four bottom enclosure front angles have
collapsed.
WARNING
15. Detach K1-BUMP from TOWER#1 as described below:
a. Remove both rear R-BLP from K1-BUMP and let them hang.
b. Pull back both rear arms of TOWER#1: they should lock back into the top enclosure.
c.
Remove both front R-BLP from K1-BUMP and let them hang.
c.
L
a.
L
16. Slightly raise the K1-BUMP.
K1_RM_EN_2-0
® ® ® ®
system system system system
b.
L
Figure 27: Separating K1-BUMP from TOWER#1
w w w . l - a c o u s t i c s . c o m
b.
L
32 32 32 32