La-Rak Rigging - L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures

K1 K1 K1 K1
reference wst reference wst reference wst reference wst
RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES
VERSION 2.0
6.1.2

LA-RAK rigging

It is possible to rig up to four LA-RAK touring racks to the K1-BUMP flying structure as it is described below. Before
applying this procedure, the K1-BUMP must have been prepared as described in [6.1.1].
All along the procedure:
•
Strictly follow the sequence of the successive steps.
•
Systematically ensure that each BLP is fully inserted by pulling on it.
WARNING
1. Take a first LA-RAK and remove the dolly board:
a. Turn a spring-loaded safety and slide out the coupling bar.
b. Repeat for the second coupling bar.
a.
2. Place the LA-RAK on a K1-BUMP 2-rail template.
The LA-RAK must be installed with front panel oriented towards the K1-BUMP laser slits (or rear
panel towards the REAR identification plate as shown in Figure 9).
WARNING
K1_RM_EN_2-0
® ® ® ®
system system system system
a.
Figure 8: Removing the dolly board from an LA-RAK
w w w . l - a c o u s t i c s . c o m
b.
14 14 14 14