L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures page 36

K1 K1 K1 K1
reference wst reference wst reference wst reference wst
RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES
VERSION 2.0
18. Remove the TOWER#1 from the rigging location.
19. Insert the four R-BLP in their shipping locations on the K1-BUMP main frame.
Note: These locations are located inside or outside the frame. The inner locations can help for shipping.
20. Lower the K1-BUMP until it is laid on the ground.
21. If necessary, remove the LA-RAK touring racks by following procedure [6.1.2] in the reversed sequence.
22. Remove the motor hooks from the K1-BUMP.
23. Set the K1-BUMP in shipping configuration by following procedure [6.1.1] in the reversed sequence.
K1_RM_EN_2-0
® ® ® ®
system system system system
Figure 29: R-BLP shipping locations on the frame
w w w . l - a c o u s t i c s . c o m
Inner Outer
shipping shipping
locations
locations
34 34 34 34