Table of Contents
Advertisement
Chapter 5. Installing Model 092 expansion enclosure
Before you start the installation process, review the procedures; ensure you follow them in the order they
are presented.
1. Read and understand the safety and weight information about the Model 092 expansion enclosure.
2. Review the installation checklist.
3. Remove the parts from the shipping container.
4. Remove parts to reduce the weight of the enclosure.
5. Install the enclosure in the rack by using the provided support rails.
6. Install the fascia.
7. Install the drives.
8. Install the cable management arm.
9. Connect the Model 092 expansion enclosures to the system.
The tools and the number of persons that are required are as follows:
• Three or more persons or a lifting device to support the enclosure
• Box cutter
• Screw driver
• Two 16 A power distribution units (PDU) IEC 60320 J and power cables
Checklist: Unpacking and installing Model 092 expansion enclosure
Before you unpack and install the Model 092 expansion enclosure, ensure that you review and follow the
installation checklist and the safety notices.
CAUTION:
The weight of this part or unit is more than 55 kg (121.2 lb). It takes specially trained persons, a
lifting device, or both to safely lift this part or unit. (C011)
CAUTION: To avoid personal injury, before lifting this unit, remove all appropriate subassemblies
per instructions to reduce the system weight. (C012)
Important: Before you unpack, move, install, or service the Model 092 expansion enclosure and its parts,
always complete the following tasks:
• Read and follow the safety notices and instructions. For more information, see "Danger and caution
notices" on page 4.
• Read and follow the guidelines that are described in Chapter 2, "Weight considerations: Model 092
expansion enclosure," on page 15.
• Ensure that a suitably rated mechanical lift is available to support the weight of the expansion enclosure
as it inserted into the rack for installation.
The Model 092 expansion enclosure and most parts are shipped together in one large box. A tray on the
top of the enclosure contains the front fascia (1U and 4U pieces), the cable management arm (CMA), and
©
Copyright IBM Corp. 2020
39
Advertisement
Table of Contents
