Installing A Centerplane Support Board - Sun Microsystems Sun Fire E25K Service Manual

Cutout handles
Carrier plate
Insert-eject
captive screw
FIGURE 11-2
11.2.4

Installing a Centerplane Support Board

1. Holding the centerplane support board close to the carrier plate, connect the LED
cable into the connector (J6) on the centerplane support board.
2. Install the centerplane support board, aligning the mounting holes with the
standoffs.
3. Using a Phillips No. 2 screwdriver, loosely secure the centerplane support board
with the two (2) M3 cross-slotted shoulder panhead screws through the board and
into the standoffs on the carrier plate, until the board is evenly positioned with
the screws.
4. Secure the eight (8) M3x8 panhead screws.
5. Firmly secure the centerplane support board to the carrier plate with the two (2)
M3 cross-slotted shoulder panhead screws.
11-6 Sun Fire E25K/E20K Systems Service Manual • April 2004
J6 LED connector
M3 cross-slotted shoulder
panhead screw
Insert-eject
captive screw
Centerplane Support Board and Carrier Plate
M3 cross-slotted shoulder
panhead screw
M3x8
panhead
screws
Carrier plate
standoffs
(10)
Centerplane
support board