Installing The Dat Peripheral On The System Control (Sc) Peripheral Board - Sun Microsystems Sun Fire E25K Service Manual

Forward mounting
panel to DVD-ROM/DAT
components
DAT component
DAT mounting
holes (4)
FIGURE 7-5
7.5.2 Installing the DAT Peripheral on the System
Control (SC) Peripheral Board
1. With the SC peripheral board in horizontal position, insert a new DAT into the
bottom bay with the mounting holes aligned upward.
2. Push the DAT peripheral inward until the front-panel bezel meets the SC
peripheral board housing.
3. Align the four (4) holes of the side-panel sheet metal with the four (4) holes of the
DAT peripheral.
4. Secure the DAT peripheral to the SC peripheral board housing with the four (4)
M3x6 panhead screws.
5. Connect the DAT PWR cable and the SCSI ribbon cable connectors.
6. Install the center SCSI access panel and secure with the four (4) M3x6 flathead
screws.
7. Install the SC peripheral board.
See Section 7.2.4, "Installing a System Control (SC) Peripheral Board" on page
8. Close the Sun Fire E25K/E20K system cabinet access doors.
M3x6 panhead DAT
mounting screws (4)
SC Peripheral Board DAT Removal and Access Panel—Exploded
SCSI cable
Chapter 7 System Control (SC) Peripheral Board
Center SCSI
access panel
M3x6 flathead DAT
mounting screws (4)
7-7.
7-15