To Level The Library; Installing The Tape Cartridges; To Label A Cartridge - Sun Microsystems StorEdge L11000 User Manual

To Level the Library

1. Lower each foot of the library until it makes contact with the floor.
2. Apply a 1/4 turn clockwise with the open-end wrench to tighten each foot against
the floor.
3. Center a carpenter's level on the top front edge of the library.
4. Check the gauge on the level. If the front of the library is level, proceed to step 6.
If it is not level:
a. Determine the tilt of the library.
b. Lower the foot on the low side of the library by applying a 1/4 turn with the
open-end wrench.
c. Repeat this step until the front is level.
5. Repeat Step 3 and Step 4 for the left edge, back edge, and right edge of the library.
6. Recheck the level on all top edges.
7. If necessary, repeat step 3 and step 4 until all four top edges of the library are
level.

Installing the Tape Cartridges

To install the tape cartridges, you need to:
Label each cartridge
Set the write-protect switch
Place cartridges in the fixed bins
Caution – Handle tape cartridges with care. Do not drop or bang them, or place
them near anything magnetic.

To Label a Cartridge

Attaching a bar code label to each tape cartridge enables the library to identify the
cartridge quickly, thereby speeding up inventory time.
36 Sun StorEdge L11000 User's Guide • September 1998