Sun Microsystems Sun Fire E25K Service Manual page 124

5. Review the platform message log to verify SMS has received the message that the
component has been removed, by typing:
sc% showlogs -F
Review the board removal message. You will see a message similar to the one below.
Jun 16 14:28:05 2003 sun15-sc0: esmd[7167]: [0 4824421445907014
NOTICE Boards.cc 1646] HPCI at IOxx removed
where xx is the hsPCI+ assembly 0-17.
9.1.2.4 Installing an hsPCI+ (slot 1) Assembly
1. To install a hsPCI+ (slot 1) assembly, firmly grasp the board assembly, supporting
the bottom with the other hand, and position it onto the carrier rail.
2. With the insert-eject lever extended, slide the board into the slot until it begins to
connect with the expander connector.
3. Apply firm pressure to the face plate to properly seat the board with the expander
connector.
4. Use the insert-eject lever to fully seat and automatically lock the board into
position.
Failure of the service LED to transition from on to off within 60 seconds after
insertion indicates a power-status control fault.
5. Verify the LED status per
6. Install all I/O cables.
9-6 Sun Fire E25K/E20K Systems Service Manual • April 2004
.
TABLE 9-2