System Chassis And Carrier Plate Labels - Sun Microsystems Sun Fire E25K Service Manual

B.2

System Chassis and Carrier Plate Labels

The label in
chassis inside the doors on the front and rear sides of the system. It may also appear
on some carrier plates. FOLLOW THESE DIRECTIONS CAREFULLY TO AVOID
DAMAGED CONNECTORS. See
on page 10-2
IMPORTANT:
Follow carrier plate
installation procedures
to avoid damaged connectors.
Refer to manual for more
information.
Attach grounding strap
before handling
carrier plate.
Carrier Plate Removal
Loosen 2 screws
simultaneously to
remove carrier
plate.
Carrier Plate Installation
Note top and bottom
alignment tabs.
Tabs
Align carrier plate with
bottom card guide.
Align carrier plate with
top card guide.
FIGURE B-2
B-2 Sun Fire E25K/E20K Systems Service Manual • April 2004
is displayed on the inside left and right side of the frame of the
FIGURE B-2
for complete instructions on the handling of the system carrier plates.
Push the carrier plate
evenly into card cage.
Use both hands to turn the
screws simultaneously 3
full revolutions.
Push firmly on the center
bracket.
Confirm that top and bottom
alignment tabs are inserted
into alignment slots
Slots
System Chassis and Carrier Plate Label—Carrier Plate Installation Procedures
Section 10.1, "Inserting a Board Set Carrier Plate"
PUSH
ONLY
IN THE
CENTER!
1 Revolution
1 Revolution
Tabs
Repeat steps 5, 6, and 7
until screws are hand tight.
3 Revolutions Push
Find the two torque
drivers located inside
the front right door.
Use only the 2 torque
drivers provided to tighten
screws simultaneously. Stop
when torque driver handle
clicks on each screw.
Return torque drivers to door
bracket for future use.