Sun Microsystems Sun Fire E25K Service Manual page 122

3. If available, examine any DStop or RStop files located in
/var/opt/SUNWSMS/adm/domain_id/dump.
where domain_id is the domain letter.
4. On the specific domain(s), use adb to examine any core files in
/var/crash/hostname.
9.1.2.2 Powering Off an hsPCI+ (Slot 1) Assembly
1. Check the power state of the board to be removed by typing:
sc% showboards | grep IOx
where x is the hsPCI+ assembly 0-17.
If the board is powered off, go to
I
Assembly" on page
If the power state is On and the board status is Isolated and not part of the
I
domain, power off the hsPCI+ by using the Sun Management Center or by typing
the following SMS command:
sc% poweroff IOx
where x is the hsPCI+ assembly 0-17, and go to
hsPCI+ (Slot 1) Assembly" on page
2. If the board is part of a multi-board domain or a single-board domain, do the
following:
Terminate all input/output device operations associated with the I/O board to be
I
deconfigured.
For multi-board domain, using dynamic reconfiguration, deconfigure the hsPCI+
I
from the running domain by using the Sun Management Center or by typing the
following SMS command:
sc% deleteboard IOx
where x is the hsPCI+ assembly 0-17, and go to
hsPCI+ (Slot 1) Assembly" on page
9-4 Sun Fire E25K/E20K Systems Service Manual • April 2004
Section 9.1.2.3, "Removing an hsPCI+ (Slot 1)
9-5.
9-5.
9-5.
Section 9.1.2.3, "Removing an
Section 9.1.2.3, "Removing an