Installing A System Board; Figure 16 Pci Front Cover Installation - Sun Microsystems Sun Enterprise 10000 Instructions Manual

PCI Front Cover Installation
FIGURE 16
9. Replace the system board cover and secure with screws by tightening to a torque
setting of 0.8 Nm (7.1 inch-pounds).

Installing a System Board

1. To confirm that the event monitoring daemon is running, type:
ssp% edd_cmd
The returned message should show State = started-monitoring. If it does
not, you must restart the event monitoring daemon by typing the following:
ssp% edd_cmd -x start
Refer to edd(1M) and edd_cmd(1M) for additional information.
2. To install a system board, firmly grasp the board by the insertion handles and
position it onto the card cage rail.
3. With the handles extended, slide the board into the slot until it begins to mate
with the centerplane connector.
4. Apply firm pressure to the faceplate to engage the board with the centerplane
connector.
5. Use the insertion handles to fully seat the board.
Installing PCI Components on the Sun Enterprise 10000 System
PCI front cover
15