Carrier Plate Replacement For Standard Configurations Of Slots 4, 5, 13, And; Figure 10-4 Securing The Center Guide Bracket After The T-Rail Guide Removal - Sun Microsystems Sun Fire E25K Service Manual

M3x8 plastic-coated
flathead screw
FIGURE 10-4
7. Discard any remaining hardware supplied with the FRU package.
10.2.4 Carrier Plate Replacement for Standard
Configurations of Slots 4, 5, 13, and 14
1. Remove the carrier plate from the system.
Note – Follow the instructions in
page 12-5
2. Remove the expander board from the carrier plate, as required, and set aside. No
modifications are required for this standard carrier plate configuration.
Note – The Sun Fire E25K system has an expander board installed on each carrier
plate (with air dam) at slots 4, 5, 13 and 14. The Sun Fire E20K system only has an
expander installed on the slot 4 through slot 5 carrier plates. Slot 13 and slot 14 are
filled with filler panels.
3. Re-install the expander board, as required, on the new carrier plate.
4. Install the new carrier plate into the system.
10-8 Sun Fire E25K/E20K Systems Service Manual • April 2004
Securing the Center Guide Bracket After the T-Rail Guide Removal
and Section 12.2.4, "Installing an Expander Board" on page
Section 12.2.3, "Removing an Expander Board" on
12-7.