Figure 16-13 Topcap Cable - Sun Microsystems Sun Fire E25K Service Manual

6. At the rear of the system, remove the twenty-two (22) M4x30 panhead screws
retaining the air plenum cover, and remove both the plenum cover and the
honeycomb EMI filter panel.
7. Reach inside the air plenum and release the two (2) male jackscrews holding the
internal cable connector to the internal chassis side panel.
8. To remove the right-angle connector, release the two (2) female jack screws using
a 3/16-inch nut driver.
9. Remove the external right-angle connector (P/J11) from the chassis side panel
( ).
FIGURE 16-13
TopCap
12V power cable
TopCap Cable
FIGURE 16-13
10. Remove the TopCap cable.
Front
Chapter 16 Cable Replacement Procedures
TopCap cable
P/J11
Rear
16-19