I/O (Slot 1) Filler Panel Replacement Procedures; Removing An I/O (Slot 1) Filler Panel; Installing An I/O (Slot 1) Filler Panel - Sun Microsystems Sun Fire E25K Service Manual

9.4 I/O (Slot 1) Filler Panel Replacement
Procedures
9.4.1

Removing an I/O (Slot 1) Filler Panel

Caution – Be sure you are properly grounded before you begin the hardware
removal and installation. There are four ground points on the system cabinet, two at
the front top left and top right, and two at the rear top left and top right.
1. Open the Sun Fire E25K/E20K system cabinet access doors.
2. Insert a Phillips No. 1 screwdriver into the pawl latches, turning counterclockwise
to release the lever, and lift the carrier insert-eject lever.
3. Use the front handle to extract the I/O (slot 1) filler panel, supporting the bottom
with the other hand, and place on a flat, sturdy, surface.
9.4.2

Installing an I/O (Slot 1) Filler Panel

1. Firmly grasp the I/O (slot 1) filler panel by the front handle, supporting the
bottom with the other hand, and position it onto the carrier rail.
2. With the insert-eject lever extended, slide the panel into the slot until it is even
with the other boards.
3. Use the front handle to fully position the panel.
4. Lock the I/O (slot 1) filler panel by sliding the insert-eject lever into position until
it is fully nested with the front handle.
5. Close the Sun Fire E25K/E20K system cabinet access doors.
Chapter 9 I/O (Slot 1) Assemblies 9-11