Replacing Parts with the Power Off
Controller Board
You must turn off the power to replace the controller board in either the Sun
StorEdge A1000 and D1000 versions of the system.
To Remove the Controller Board
1. Stop the software communication with the Sun StorEdge A1000 or D1000 system.
See the documentation that came with your software.
2. Turn off the power to the system.
Push the power switch to the standby position. Press the left side of the switch.
3. Remove the SCSI cables and terminators on the controller board.
4. Attach an antistatic wrist strap to the exposed metal part of the chassis at the
center post between the power supply bays.
26
Sun StorEdge A1000 and D1000 Installation, Operations, and Service Manual • February 1998