Assembly
(3)
Install dust seal (11), back up ring (10)
and rod seal (9) to body (1).
When installing dust seal (11) and rod
seal (9), take full care so as not to
damage the lip.
Pour grease into body (1), then push in
rod (12) by hand.
After take grease out of grease valve
mounting hole, let air out.
If air letting is not sufficient, it may be
difficult to adjust the tension of crawler.
Fit grease valve (13) to rod (12).
Tightening torque : 13 1.0 kgf m
Install spring (3) and bracket (4) to body
(1).
Apply pressure to spring (3) with a press
and tighten lock nut (5).
Apply sealant before assembling.
During the operation, pay attention
specially to prevent the press from
slipping out.
(94 7.2 lbf ft)
8-225
8-225
1
9 10 11
R210UCG2(3)
1
12
13
R210UCG2(4)
Press
4
3
R210UCG2(5)