Hyundai HX145LCR Manual page 579

(15)
Disassembling the spring of the cylinder block
Put the cylinder block (4) on the pressurize jig.
Press the washer (10) with pressurize jig, and re-
move the spring (14) after snap ring (45) removed.
Put a vinyl cover on the sliding surface of cylinder
block (4) for protection.
Do not remove spring (14) if it not to be replace.
Remove the snap ring (45), washer (10), spring
(14) and washer (10) from cylinder block (4).
(16) Disassembling the shaft
Remove swash plate (3) from the shaft (2).
Remove shaft (2) from the spindle (101).
When separating the swash plate, separate and
turn it by using hands to free from intervention of
the stopper.
Remove speed selector piston assembly [piston
(61) and shoe (62)] form the spindle [101] by
feeding compressed air into the access hole in
spindle (101).
Remove parallel pins (42, 2EA) and pivots (67,
2EA) from the spindle (101).
Remove roller bearing (49) from the spindle (101).
Piston assembly ; Piston (61), Shoe (62)
Compressed air ; 3~5 kgf/cm
When piston (61) or shoe (62) is damaged, if ex-
change is necessary, they have to be exchanged
together because the separation is impossible.
Use the protection cover on the upper part spindle
when users put the compressed air into suddenly.
Otherwise part damage and accident might go on
because the piston is rushed out of the spindle.
2 (43~71 psi)
8-108
14098TM34
14098TM35
14098TM36
14098TM37