3) 3)
ASSEMBLY
ASSEMBLY
※
Even though assembly is accomplished by
reversing disassembly steps, be careful of the
following.
①
Repair the damaged part when disassemblying
and prepare parts for exchange in advance.
②
All parts should be cleaned with cleaner, dried
with compressed air.
③
Sliding surface, O-ring, bearing and oil seal
should be lubricated with clean hydraulic oil,
prior to final assembly.
④
Replacement of O-ring and oil seal with new
parts is generally recommended.
⑤
Use a torque wrench to make sure that
assembly fasteners are tightened to specified
values.
⑥
When assembling bolt, spread loctite.
(1)
Put casing (1) on worktable.
Press oil seal (2) using oil seal jig, until it reach
the bottom.
※
Spread grease on external diameter of oil seal.
(2)
Mount cylinderical roller bearing (5, 6) on shaft
(3) using shrink fitting method.
8-53
125LCR8SM23
125LCR8SM24