Hyundai HX145LCR Manual page 533

3) ASSEMBLY
Even though assembly is accomplished by
reversing disassembly steps, be careful of the
following.
Repair the damaged part when disassemblying
and prepare parts for exchange in advance.
All parts should be cleaned with cleaner, dried
with compressed air.
Sliding surface, O-ring, bearing and oil seal
should be lubricated with clean hydraulic oil,
prior to final assembly.
Replacement of O-ring and oil seal with new
parts is generally recommended.
Use a torque wrench to make sure that
assembly fasteners are tightened to specified
values.
When assembling bolt, spread loctite.
Carrier No.1 sub assembly
(1) After heating the carrier No.1 (17), assemble
carrier pin No.1 (21) to the side without
thehole.
(2) After drilling 6 hole, assemble spring pin
(15).(3 pcs)
8-70
125LCR8SM84
125LCR8SM85