Table of Contents
Advertisement
Table 5-6. OSA Warnings (11 of 12)
Error Number
Error Description [description/explanation/examples]
6742
desc = "Requested amplitude not found"
help = "A math expression to search for a specific amplitude in a trace did not
succeed. There are no trace points with the desired amplitude."
6744
desc = "Excursion should be in dB"
help = "The units for the excursion are not in dB."
6745
desc = "Log of a negative number is not allowed."
help = "During evaluation of a math expression the logarithm of a negative
number was encountered."
6746
desc = "Math expression contains a circular reference."
help = "A new math expression was entered. The expression was rejected
because it would create a circular reference. For example if trace math for trace
C is set to (A-B) then setting trace math for trace B to (C+D) would create a
circular reference."
6747
desc = "Next peak not found"
help = "A next-peak search was requested. There are no more peaks on the
current marker's trace in the requested direction. To find additional peaks
reduce the marker peak excursion setting or adjust sensitivity."
6748
desc = "Next pit not found"
help = "A next-pit search was requested. There are no more pits on the current
marker's trace in the requested direction. To find additional pits reduce the
marker pit excursion setting or adjust sensitivity."
6749
desc = "Peak not found"
help = "A peak search was requested. There are no valid peaks on the current
marker's trace. Try decreasing the marker peak excursion setting or adjust the
sensitivity setting."
6750
desc = "Pit not found"
help = "A pit search was requested. There are no valid pits on the current
marker's trace. Try decreasing the marker pit excursion setting or adjust the
sensitivity setting."
6751
desc = "Trace has no centroid"
help = "The trace has no centroid. This may occur because the sum of trace
points' amplitudes is zero or there a no trace points."
6752
desc = "The reference point is outside trace bounds"
help = "The reference point's wavelength is either too small or too large. The
reference point will be clipped to a trace endpoint."
Status Listings
OSA Warnings
5-27
Advertisement
Table of Contents
