Agilent Technologies 86142B User Manual page 146

Key Path
Remote
Commands
N o t e
N o t e
Key Path
Printer Setup
Accesses the printer setup panel that allows you to select either the internal
printer or external printer as the print destination.
System > Printer Setup
HCOPy:DESTination
Printer Shares
Uses the LAN (local area network) to print data to network printers. The data
can be printed on designated, PCL3 format or newer printers.
To access the printer share softkeys, you must first configure the network
refer to "Connecting to the OSA over the Network" on page 4-6
user share identity/user profile information for remote shares
Sharing and Printing over a Network" on page
printer share will then become available for selection.
Samba ® or Microsoft ®
If networking is not configured, the command will generate a "Settings conflict"
error.
System > More System Functions > GPIB & Network Setup > Printer Shares
Recall (Recall Setup Panel)
Selects whether all measurement data or only trace data will be recalled from
internal memory or floppy disk or network file shares.
ment and Trace Data" on page 2-24
When Measurement (All Visible + State) is selected, all instrument conditions
will be recalled. When the file is recalled, the instrument state will be set to
the same state as when the file was saved.
software must be installed to run the file share programs.
Function Reference
Printer Setup
and enter the
(refer to "File
2-26). The softkeys for file and
See "Recalling Measure-
3-67