®
R&S
NGE100B
SYSTem:COMMunicate:WLAN[:STATe] <arg0>
This command activates/deactivates or queries the enable state of the wireless inter-
face.
Available only if option R&S NGE-K102 is installed.
Parameters:
<arg0>
SYSTem:COMMunicate:WLAN:PASSword <arg0>
This command defines the password string of the Access Point when the wireless
interface works as a client.
Available only if option R&S NGE-K102 is installed.
Parameters:
<arg0>
Usage:
SYSTem:COMMunicate:WLAN:SSID <arg0>
This command defines or queries the SSID string of the access point when the wire-
less interface works as a client.
Available only if option R&S NGE-K102 is installed.
Parameters:
<arg0>
6.5.3 Firmware Update
DIAGnostic:SERVice:FWUP <arg0>
Starts instrument firmware update remotely.
For more information, see
Parameters:
<arg0>
Example:
Usage:
6.5.4 HCOPY
HCOPy:DATA?
This command queries current screen content. BMP format is supported.
User Manual 5601.1343.02 ─ 04
Setting only
Chapter 5.7.6, "Updating the
DIAGnostic:SERVice:FWUP "NGE100FWRelease.tar.gz.enc"
Setting only
Remote Control
Remote Control - Commands
Firmware",
on page 58.
79