Setting The Matrix Ir Channel - Gefen GEF-UHD-89-HBT2 User Manual

Use this menu option to set the IR channel of the matrix. In order for the included IR
remote to work with the matrix, both the matrix and the IR remote control must be set
to the same IR channel. See
setting the IR channel for the IR remote control
1. Go to the routing screen. If the routing screen is not displayed, then press the
Back button on the front panel or on the IR remote control until the routing screen
is displayed.
2. Press and release the Menu button on the front panel or on the IR remote control.
The Menu button, on the front panel, will momentarily flash blue when it is pressed.
*Preferred
®
Setup
4K Ultra HD 8x9 Matrix for HDMI
w/ HDCP 2.2, HDBaseT™ & POH
Local Power
GEF-UHD-89-HBT2
A B
HDMI
Ethernet IR In/Ext IR All Local Out
IP Control
Out
C D
In
E F
RS-232
G H Mask
Output
RS-232 IR IR Pwr HDBaseT™
In/Ext Out POH Input
*Preferred
Menu Preset
®
OK
Back Lock
4K Ultra HD
1 2 OFF
HDBaseT ™ Receiver
w/ HDCP 2.2, POH, Ethernet,
RS-232 & 2-way IR
3 4
HDMI
Ethernet
Out
5 6
7 8
Input
*Preferred
®
RMT-89L

Setting the Matrix IR Channel

Setting the IR Channel (page 10)
Menu
Enter
Back
3. The Setup menu will be displayed:
setup
RS-232
RS-232 RS-232 RS-232
A B C
IR In IR In IR In
IR In
1 2 3
IR Out IR Out IR Out IR Out
Press and release the ▲ or ▼ buttons on the
4.
front panel or on the IR remote control,
to select the System menu:
System
Press the Enter button on the front panel.
5.
If using the included IR remote control, press the
OK button.
ON
6. Press the ▲ or ▼ buttons on the front panel
1 2
or on the IR remote control to select the IR
Channel menu.
The current IR channel will be displayed.
IR channel
1
page | 73
for more information on
Preset
IR
Lock
HDBaseT™ POH Outputs
RS-232 RS-232 RS-232 RS-232
D E F G
IR In IR In IR In
4 5 6 7
IR Out IR Out IR Out
HDMI Inputs
Menu System
Power
H
IR In
8
IR Out