Table of Contents
Advertisement
Getting Started
The IR remote control unit ships with two batteries. Only one battery is required for
operation. The second battery is a spare. Use only 3V CR2032-type batteries.
1.
Remove the back cover the IR Remote Control unit.
2.
Insert the included battery into the primary battery slot. The positive (+) side of the
battery should be facing up.
3.
Replace the back cover.
WARNING: Risk of explosion if battery is replaced by an incorrect
type. Dispose of used batteries according to the instructions.
In order for the included IR remote control to communicate with the 4x1 HD Switcher w/
Audio Decoding, the IR remote control must be set to the same channel as the processor.
See the section
Setting the Switcher IR Channel
channel of the 4x1 HD Switcher w/ Audio Decoding.
Installing the Battery
Setting the Remote IR Channel
DIP switches
page | 9
IR Remote Control Unit
or use the
IR
command to set the IR
Channel 0 (default):
Remote Channel 1:
ON
ON
1
2
1
1
Remote Channel 2:
Remote Channel 3:
ON
ON
1
2
1
2
2
2
Advertisement
Table of Contents
