Installing The Battery; Setting The Ir Channel - Gefen EXT-DVIKVM-241DL User Manual

The Remote Control unit ships with two batteries. One battery is required for
operation and the other battery is a spare.
1. Remove the battery cover on the back of the IR Remote Control unit.
2. Insert the included battery into the open battery slot. The positive (+) side of
the battery should be facing up.
3. Replace the battery cover.
Battery slot
The IR channel on the IR Remote Control must match the IR channel used by the
2x1 DVIKVM Switch. For example, if both DIP switches on the IR Remote
Control unit are set to IR channel 0 (both DIP switches down), then the 2x1
DVIKVM DL Switch must also be set to IR channel 0. See page 13 for
information on how to change the IR channel on the 2x1 DVIKVM DL Switch.
WARNING: Risk of explosion if battery is replaced by an incorrect
type. Dispose of used batteries according to the instructions.
IR REMOTE CONTROL

Installing the Battery

DIP switches

Setting the IR Channel

7
Channel 0 (default): Remote Channel 1:
ON
1 2
Remote Channel 2: Remote Channel 3:
ON
1 2
ON
1 1 2 2
ON
1 2