Ir All In Port - Gefen GEF-UHD-89-HBT2 User Manual

4K Ultra HD 8x9 Matrix for HDMI
w/ HDCP 2.2, HDBaseT™ & POH
Connect an electrical IR cable, from an automation control system, to this port.
IR signals that are received by this port are transmitted to Receiver units. The IR signal
is then sent to each IR emitter. Use this port to control a specified display (sink) device.
Note that IR routing cannot be changed when using this port. To allow independent IR
routing, separate from video routing, see the
GEF-UHD-89-HBT2
Ethernet IR In/Ext
IP Control
Automation
Control Device
RS-232
4K Ultra HD
HDBaseT ™
w/ HDCP 2.2, POH, Ethernet,
RS-232 & 2-way IR
Ethernet

IR All In Port

HDMI
IR All Local Out
Out
In
RS-232
8x
Sources
IR IR Pwr HDBaseT™
In/Ext Out POH Input
*Preferred
®
Receiver
HDMI
Out
page | 29
IR In Ports (page 30)
RS-232
RS-232
A
IR In
IR In
1
IR Out
IR Out
Matrix
8x
Receiver units
IR emitter
Back
IR Control
section.
RS-232
B
IR In
2
IR Out
Display
RS-232
C
IR In
3
IR Out