The following RS-232 settings are only required for controlling the matrix. When controlling
RS-232 devices that are connected to Receiver units, consult the documentation for the
RS-232 device.
1.
Launch the desired terminal application.
2.
Selected the desired COM port.
3.
Configure the RS-232 port to the following settings. Only TxD, RxD, and GND pins
are used.
Description
Baud rate
Data bits
Parity
Stop bits
Hardware flow control
4.
Connect to the RS-232 port.
#help
5.
Type
for a list of commands or refer to the tables on the following pages.
RS-232 Configuration
Setting
19200
8
None
1
None
page | 131
Using Telnet, UDP, and RS-232