Table of Contents
Advertisement
Operating the 4x2 Switcher for HDMI 1.3
Setting the Switcher IR Channel
In order for the 4x2 Switcher for HDMI 1.3 to communicate with the included IR remote
control unit, the switcher must be set to the same channel as the IR remote. Use the
following procedure to set the IR channel of the switcher.
NOTE: When the 4x2 Switcher for HDMI 1.3 is power-cycled or
reset, the Input Indicators will briefly flash, displaying the current IR
channel setting.
1.
Make sure that the 4x2 Switcher for HDMI 1.3 is powered.
Press and hold the EDID button.
2.
While depressing the EDID button, press and release the Reset button to cycle
3.
through each of the IR channel settings.
The current IR channel setting will be displayed by the flashing Input Indicators
on the ront panel:
Channel 0
Channel 2
4.
After the correct IR channel has been set, release the EDID button.
EDID button
Reset button
Channel 1
Channel 3
page | 10
Advertisement
Table of Contents
