Ip Settings - Gefen GEF-UHD-89-HBT2 User Manual

Use this menu option to set the IP mode, IP address, subnet mask, gateway, and HTTP
port of the matrix.
1. Go to the routing screen. If the routing screen is not displayed, then press
the Back button on the front panel or on the IR remote control until the routing screen
is displayed.
2. Press and release the Menu button on the front panel or on the IR remote control.
The Menu button, on the front panel, will momentarily flash blue when it is pressed.
*Preferred
®
Setup
4K Ultra HD 8x9 Matrix for HDMI
w/ HDCP 2.2, HDBaseT™ & POH
Local
Power
GEF-UHD-89-HBT2
A B
HDMI
Ethernet IR In/Ext IR All Local Out
IP Control
Out
C D In
E F
RS-232
G H Mask
Output
RS-232 IR IR Pwr HDBaseT™
In/Ext Out POH Input
*Preferred
Menu Preset
®
OK
Back Lock
4K Ultra HD
1 2 OFF
HDBaseT ™ Receiver
w/ HDCP 2.2, POH, Ethernet,
RS-232 & 2-way IR
3 4
HDMI
Ethernet
Out
5 6
7 8
Input
*Preferred
®
RMT-89L
6. Press the Enter button on the front panel or the OK button on the IR remote control
to display the IP Mode screen. The current network mode will be displayed.

IP Settings

Menu
Enter
Back
The Setup menu will be displayed:
2.
setup
RS-232 RS-232 RS-232
RS-232
A B C
IR In IR In IR In IR In
1 2 3
IR Out IR Out IR Out IR Out
3. Press and release the ▲ or ▼ buttons on the
front panel or on the IR remote control,
to select the Network menu:
network
4. Press the Enter button on the front panel.
If using the included IR remote control, press the
OK button.
ON
5. The IP Settings menu will be displayed:
1 2
ip settings
page | 52
Preset
IR
Lock
HDBaseT™ POH Outputs
RS-232 RS-232 RS-232 RS-232
D E F G
IR In IR In IR In
4 5 6 7
IR Out IR Out IR Out
HDMI Inputs
Menu System
Power
H
IR In
8
IR Out