Table of Contents
Advertisement
ID
Name
5
Input buttons (1- 8) / Off
6
Lock
7
OK
8
Preset
9
Mask
10
Power
11
DIP switches
12
Battery compartment
(shown open)
Description
Press these buttons to select the desired
input when performing routing operations.
Each button corresponds to an In port
(1 - 8) on the rear panel of the matrix.
Press the Off button, followed by the
number of the input (1 - 8) to "turn off"
an input.
Press this button to lock or unlock the
matrix. Locking the matrix disables the
buttons on the front panel, IR control, and
the web interface. See
(page 86)
for more information.
Press this button to accept the current
selection in the menu system.
Press this button to select the desired
preset. See
Routing Presets (page 40)
for more information.
Press this button to mask the desired
output. See
Masking Outputs (page 36)
for more information.
Press this button to toggle between power-
on and standby. See
(page 18)
for more information.
Sets the IR channel of the IR remote
control. In order for the IR remote control
to communicate with the matrix, both the
IR remote control and the matrix must be
set to the same IR channel. See
the IR Channel (page 10)
IR channel of the IR remote control. Use
the front panel to set the IR channel of
the matrix.
Setting the Matrix IR Channel
(page 73).
Accepts two 1.5V AAA-type batteries. See
Installing the Batteries (page 9)
more information.
page | 8
Introduction
Locking the Matrix
Powering the Matrix
Setting
for setting the
for
Advertisement
Table of Contents
