#set_showme
Enables or disables the "Show Me" feature. If the "Show Me" feature is enabled,
then all the buttons (with the exception of the Power button), will flash slowly.
This feature allows the matrix to be visually identified on the network and is useful
when multiple matrix units are being used. The default setting is disabled.
Syntax
#set_showme state
Parameters
state
Type: INTEGER
Accepts a number from the table below, corresponding to the desired state.
state
0
1
Example
#set_showme 1
SET_SHOWME 1
Related Commands
#get_discovery
#set_discovery
Description
Disable "Show Me"
Enable "Show Me"
page | 192
Commands
Page Title