Querier Config - TP-Link T3700G-28TQ User Manual

Member Port Time:
Router Port Time:
Max Response
Time:
Router Ports:
UNIT:
VLAN Table

Select:
VLAN ID:
Fast Leave:
Member Port Time:
Router Port Time:
Max Response
Time:
Static Router Ports:
Dynamic Router
Ports:
Configuration procedure:
Step Operation
1 Enable MLD
function
2 Configure the
parameters for VLANs

9.2.4 Querier Config

In an IP multicast network that runs MLD, a Layer 3 multicast device works as an MLD querier to
send MLD queries and manage the multicast table. But MLD is not supported by the devices in
Specify the aging time of the member port. Within this time, if
the switch doesn't receive MLD report message from the
member port, it will consider this port is not a member port any
more.
Specify the aging time of the router port. Within this time, if the
switch doesn't receive MLD query message from the router
port, it will consider this port is not a router port any more.
Enter the host's maximum response time to general query
messages in a range of 1 to 25 seconds.
Enter the static router port which is mainly used in the network
with stable topology.
Select the unit ID of the desired member in the stack.
Select the desired VLAN ID for configuration. It is multi-optional.
Displays the VLAN ID.
Displays the fast leave feature of the VLAN.
Displays the member port time of the VLAN.
Displays the router port time of the VLAN.
Displays the max response time of the VLAN.
Displays the static router ports of the VLAN.
Displays the dynamic router ports of the VLAN.
Description
Snooping Required. Enable MLD Snooping globally on the switch on
Multicast→MLD Snooping→Snooping Config page.
multicast Optional. Configure the multicast parameters for VLANs
on Multicast→MLD Snooping→VLAN Config page.
If a VLAN has no multicast parameters configuration, it
indicates the MLD Snooping is not enabled in the VLAN,
thus the multicast data in the VLAN will be broadcasted.
147