TP-Link T3700G-28TQ User Manual page 296

PIM SM Static RP Config

By default, no static RP address is configured. You could configure the IP address of RPs on all
multilayer switches.
RP Address:
Group:
Group Mask:
Override:
PIM SM Static RP Table

Displays the configured static RP of this PIM SM domain.
RP Address:
Group:
Group Mask:
Override:
PIM SM Candidate RP Config

Configure the candidate RP on this device. Candidate RPs periodically send multicast
RP-announce messages to a particular group or group range to announce their availability.
Interface:
Group:
Group Mask:
Interval:
PIM SM Candidate RP Table

Interface:
Group:
Group Mask:
Interval:
Specify the IP address of the static RP.
Group Address of the RP to be created or deleted.
Group Mask of the RP to be created or deleted.
Select to enable or disable override mode. If the override
mode is enabled, the static RP will take effect no matter the
candidate RP is configured or not. Otherwise the static RP
will be invalid when the candidate RP is configured.
Displays the ip address of static RP.
Displays the group address.
Displays the group mask.
Displays the override mode. If the override mode is enabled,
the static RP will take effect no matter the candidate RP is
configured or not. Otherwise the static RP will be invalid
when the candidate RP is configured.
Select the VLAN interface of the candidate RP.
The group address
Advertisements.
The group address mask transmitted in Candidate-RP-
Advertisements.
Specify the interval of advertisement message of the
candidate RP in seconds. The default value is 60.
Displays the VLAN interface of the candidate RP.
Displays the
Candidate-RP-Advertisements.
Displays the group
Candidate-RP-Advertisements.
Displays the interval of advertisement message of the
candidate RP in seconds.
285
transmitted
group address
address mask
in Candidate-RP-
transmitted in
transmitted in