Application Example For Stack - TP-Link T3700G-28TQ User Manual

SNMP Trap status:
Allow Downgrade:

5.2 Application Example for Stack

Network Requirements

Establish a stack of ring topology with four T3700G-52TQ switches.
Network Diagram

Configuration Procedure

Configure switch A, B, C and D before physically connecting them:

Step Operation
1 Configure stack mode.
2 Configure unit ID.
3 Configure the role of
the switch in the stack.
4 Configure the Auto
Copy Software
function.
Connect the switches:

Connect switch A, B, C and D as the network diagram shows, and then power the switches on
to establish a stack.
Enable or disable SNMP trap of the Auto Copy Software
function.
Enable or disable downgrade of the new members in the Auto
Copy Software function. If you choose enable, the member's
software version is allowed to downgrade when copying
software from the master.
Description
Required. On Stack Management → Stack Config page,
configure the port's stack mode as "Stack" in Stack Port
Config section.
Optional. On Stack Management → Stack Config page,
configure the unit ID of switch A, B, C and D as 1, 2, 3 and 4
respectively in Stack Member Config section.
Optional. On Stack Management → Stack Config page,
configure the role of switch A as Master, the role of switch B,
C, D as Member in Role Config section.
Optional. On Stack Management → Auto Copy Software
page, enable Auto Copy Software function.
52
Return to CONTENTS